Page 1 of 1
*WANTED* Aluminium Riser Bars
Posted: Fri Jan 03, 2020 12:00 pm
by mfezela
± 720mm wide, ± 30mm rise.
N.B. 25.4mm clamp diameter.
Answer Protaper AM circa 2006 would be absolutely perfect.
Re: *WANTED* Aluminium Riser Bars
Posted: Fri Jan 03, 2020 6:21 pm
by redefined_cycles
Any of these 2 any good to you. The gt is 630mm(ish) and the Amoeba is 780mm(ish)...
Re: *WANTED* Aluminium Riser Bars
Posted: Fri Jan 03, 2020 7:19 pm
by mfezela
Yes to the Amoeba

Price? Paypal?
Definitely 25.4mm clamp?
P.M. sent
Regards,
Jan
Re: *WANTED* Aluminium Riser Bars
Posted: Fri Jan 03, 2020 7:29 pm
by mfezela
Looking carefully again at that Amoeba it's marked as 650mm not 780mm (ish).
If it is only 650mm, I'm not interested.
Regards,
Jan
Re: *WANTED* Aluminium Riser Bars
Posted: Fri Jan 03, 2020 9:37 pm
by redefined_cycles
mfezela wrote: ↑Fri Jan 03, 2020 7:29 pm
Looking carefully again at that Amoeba it's marked as 650mm not 780mm (ish).
If it is only 650mm, I'm not interested.
Regards,
Jan
Let me get the tape measure out again (goes to check)...
Yes... you're right. 683mm. Sorry about that.. from measuring and writing before I obviously lost a fair few mm. Soz.
Anyway, PM replied to
Thanks... Shafiq