Page 1 of 1

What's the diameter of your pot, please?

Posted: Mon Jun 11, 2012 7:13 pm
by Bearbonesnorm
Hello ... can anyone tell me the O/D of their cook pots/pans and give me the make/model?

Don't ask but thank you ;)

Re: What's the diameter of your pot, please?

Posted: Mon Jun 11, 2012 8:10 pm
by chris n
Primus ETA Express, 1L: 115mm
Primus Alutech, 0.6L: 100mm

Re: What's the diameter of your pot, please?

Posted: Mon Jun 11, 2012 8:40 pm
by gairym
GSI Outdoors 'Halulite Minimalist'

105mm (4.2") diameter.

why do you ask....?

(couldn't resist!)

Re: What's the diameter of your pot, please?

Posted: Mon Jun 11, 2012 8:44 pm
by Jack
As above GSi halulite Minimalist.. Just about to post mine when I noticed that Gairy had said that. :D Good little pot and not too expensive. I'm curious too though.. Any particular reason? :p

Re: What's the diameter of your pot, please?

Posted: Mon Jun 11, 2012 9:26 pm
by gairym
Jack wrote:As above GSi halulite Minimalist.. Just about to post mine when I noticed that Gairy had said that. :D Good little pot and not too expensive. I'm curious too though.. Any particular reason? :p
nice one. it's a nice little pot. for the money i can't fault it!

p.s. stuart - why....?

Re: What's the diameter of your pot, please?

Posted: Mon Jun 11, 2012 10:06 pm
by 99percentchimp
Evernew Ti 900ml pot - 122mm
Evernew Ti 750ml pot (solo set) - 92mm
Evernew Ti 400ml mug/pot (solo set) - 102mm

Is this a bet to see what you can get gear freaks to post? :)

Re: What's the diameter of your pot, please?

Posted: Wed Jun 13, 2012 9:53 am
by Bearbonesnorm
p.s. stuart - why....?
I'm just trying to work out if there's a common(ish) diameter, ie, as volume increases does the diameter get vastly bigger or does the height increase instead?

Re: What's the diameter of your pot, please?

Posted: Wed Jun 13, 2012 11:39 am
by pedalhead
Same as 'Chimp on these..

Evernew Ti 750ml pot (solo set) - 92mm
Evernew Ti 400ml mug/pot (solo set) - 102mm

Re: What's the diameter of your pot, please?

Posted: Wed Jun 13, 2012 1:14 pm
by gairym
s8tannorm wrote:I'm just trying to work out if there's a common(ish) diameter, ie, as volume increases does the diameter get vastly bigger or does the height increase instead?
because you're putting together a production model of a new type of stove?????