I went out on ride last night on my ss got a creking noise when going up hill/putting power down could it be the bb or hub maybe ?

Possibles.

Crank / BB interface.
BB in the frame.
BB itself ... ie it's shot.
Rear hub ... but it wouldn't be the first place I'd look.
Bars / stem.

Another one to throw into the mix is the pedals. (Recent experience of this )

Given we have entered a period of dry weather I would look for things that should be greased but are not.

On one bike dry QR give those symptoms each year in summer.

Worth noting if creak occurs when only in saddle or not.

Had a small ride this moring sometimes its really loud when going up Freehub looks okay and pedals too will check bb later its a cheap un55 shimano one being in from start of the year. Now time for BBQ and beer

greenmug wrote:
On one bike dry QR give those symptoms each year in summer.

Worth noting if creak occurs when only in saddle or not.

Where do you grease a qr sorry not good on the spanners

I put a thin layer over the whole Quick Release Skewer making sure to reach the edges. You can guess at if this is the creak problem if the creak only occurs when you put power thought the pedal and it is an even note regardless of power etc. Creaks that occurs elsewhere often exhibit a level of noise proportionate to the force you put in. On some frames it is really hard to know where the noise comes from as the tubes transport it all around. Experiment with riding out of saddle, little/no force on bars, no force on one foot then other. You might be able to eliminate a factor that gives a strong clue.

I'd expect even a cheap BB to last a good season or a few hundred miles. They often get blamed because there is often a creak just before death. However, creaks can source from almost any part of the bike where two bits of metal could potentially rub against each other.

My 2p

- pedals
- maybe chainring bolts

Thanks for all the replys will give bike a good going over tomorrow

Whats the frame / BB set up in there?