Exotic carbon monocoque 29er fork. 490mm axle to crown, 200mm steerer, bung included. Wrapped on outside edges from new and in very good condition, but, suffered a small scrape in transit to me (from the edge of a disc rotor), see photo. Each mark only a couple of mm each and fork is absolutely fine. Have had it covered while I used it but removed tape for clarity. Due to small damage, SOLD. Below is a collage, can send individual photos if needed.

Hi, is this still available or did you sell it to Alex?

Still available

Sorry Faustus, not being a d**k just getting clearance for a purchase.

Can you send me some more pics of the marks on it? You ok with the £120 you said to Alex? I’ll PM you.

No worries and yes £120 posted is good, should have updated the advert. Send me your email in the pm and I'll send photos. Ta.

Aaargh!
Apologies, going to have to change my plans. This was meant to be part of creating a gravel bike out of an old 29er frame and my wife’s gravel bike that’s too small. I am informed that the cranks won’t fit, front derailleur looking iffy and I hadn’t figured out that I’d need to fit post mount callipers so it’s working out a lot more expensive.

Sorry Faustus. I’ve previously had an exotic fork and was impressed so this looked like it was going to be perfect.

No worries at all, good luck with the build!

Final reduction down to £100 posted.

faustus wrote: ↑Thu Dec 05, 2024 5:22 pm Final reduction down to £100 posted.

I've PM'd you